input resistor 예문

예문

1. Obviously the input resistors on each channel must be sufficiently large such that they do not load the source too much.
2. So if you use 10kohm input resistors you aint going to affect the source voltage too much . talk ) 01 : 26, 29 January 2009 ( UTC)
3. These additions make two substantial improvements to the OTA . First, when used with input resistors, the diodes distort the differential input voltage to offset a significant amount of input stage non linearity at higher differential input voltages.
4. The logical operation comparison ( the input resistor network acts as a parallel " voltage summer " with equally weighted inputs and the following common-emitter transistor stage as a " voltage comparator " with a threshold about 0.7 V ).
5. Using typical values of the reference resistors R _ { p } and R _ { n } of 10k ohms and an input resistor of 50k ohms, we can achieve a 16 bit resolution during the run-up phase with 655360 periods ( 65.5 milliseconds with a 10 MHz clock ).